The word “coating” in the passage is closest in meaning to
[#paragraph1]Most of the world’s potable water—freshwater suitable for drinking—is accounted for by groundwater, which is stored in the pores and fractures in rocks. There is more than 50 times as much freshwater stored underground than in all the freshwater rivers and lakes at the surface. Nearly 50 percent of all groundwater is stored in the upper 1,000 meters of Earth. At greater depths within Earth, [#highlight1]the pressure of the overlying rock[/highlight1] causes pores and cracks to close, reducing the space that pore water can occupy, and almost complete closure occurs at a depth of about 10 kilometers. The greatest water storage, therefore, lies near the surface.
[#paragraph2]Groundwater is stored in a variety of rock types. A groundwater reservoir from which water can be [#highlight3]extracted[/highlight3] is called an aquifer. We can effectively think of an aquifer as a deposit of water. Extraction of water depends on two properties of the aquifer: porosity and permeability. Between sediment materials (such as sand or small rocks) that are deposited by water, wind, or glacial ice grains are spaces that can be filled with water. This pore space is known as porosity and is expressed as a percentage of the total rock volume. Porosity is important for water-storage capacity, but for water to flow through rocks, the pore spaces must be connected. The ability of water, or other fluids, to flow through the interconnected pore spaces in rocks is [#highlight4]termed[/highlight4] permeability. Fractures and joints have very high permeability. In the intergranular spaces of rocks, however, fluid must flow around and between grains in a tortuous path; this winding path causes a resistance to flow. The rate at which the flowing water overcomes this resistance is related to the permeability of rock.
[#paragraph3]Sediment sorting and compaction influence permeability and porosity. The more poorly sorted or the more tightly compacted a sediment is, the lower its porosity and permeability. Sedimentary rocks—the most common rock type near the surface—are also the most common reservoirs for water because they contain the most space that can be filled with water. Sandstones generally make good aquifers, while finer-grained mudstones are typically impermeable. Impermeable rocks are referred to as aquicludes. Igneous and metamorphic rocks are more [#highlight6]compact[/highlight6], commonly crystalline, and rarely contain spaces between grains. However, even igneous and metamorphic rocks may act as groundwater reservoirs if extensive fracturing occurs in such rocks and if the fracture system is interconnected.
[#paragraph4]The water table is the underground boundary below which all the cracks and pores are filled with water. In some cases, the water table reaches Earth’s surface, where it is expressed as rivers, lakes, and marshes. [#insert1] Typically, though, the water table may be tens or hundreds of meters below the surface. [#insert2] The water table is not flat but usually follows the contours of the topography, the shape of a surface such as Earth’s, including the rise and fall of such features as mountains and valleys. [#insert3] Above the water table is the vadose zone, through which rainwater percolates. [#insert4] Water in the vadose zone drains down to the water table, leaving behind a thin [#highlight9]coating[/highlight9] of water on mineral grains. The vadose zone supplies plant roots near the surface with water.
[#paragraph5]Because the surface of the water table is not flat but instead rises and falls with topography, groundwater is affected by gravity in the same fashion as surface water. Groundwater flows downhill to topographic lows. [#highlight11]If the water table intersects the land surface, groundwater will flow out onto the surface at springs, either to be collected there or to subsequently flow farther along a drainage.[/highlight11] Groundwater commonly collects in stream drainages but may remain entirely beneath the surface of dry stream-beds in arid regions. In particularly wet years, short stretches of an otherwise dry stream-bed may have flowing water because the water table rises to intersect the land surface.